Help with lower intake gaskets *pics*

ShortThrow50

Member
Oct 22, 2006
923
2
16
Pa
I did tfs h/c/i. I sprung a little coolant leak so im replacing the gaskets and gonna do it right this time. Im gonna put some black rtv around the coolant passages this time. I bought a new felpro gasket kit and confused about some things. I labeled the picture with numbers.

whats 1 and 2 for?
Do i cut number 3 to fit the water passages?



intakenl0.webp

thanks
 
#1 is if you have an active EGR system you put those on the spots in the middle of the gasket, like a puzzle piece.

#2 if you have eliminated or plan to block the EGR you install those instead.

Either way make sure you cut out the small leg that is in each water port #3 and but rtv around them, I also prefer to use a bead across the front and rear of the intake as well instead of the cork pieces.

The ??? is a new oring for the dist, yours is most likely dry rotted...
 
Yup and if you do use the cork for the lifter valley (front and rear) don't forget some RTV on the 4 corners where the intake meets the head and engine block (lifter valley).