I know I'm a few steps ahead of myself here, and again forgive my ignorance but I need some advice on certain choices I've made.
I've decided to use an aftermarket 351w shortblock with a forged rotating assembly to be the core of this engine. Just wondering in terms of intake manifold, cylinder head, camshafts I should use? I like the Trickflow Box-R Intake with the 13.3" runners with the AFR 225 heads which seems to compliment a twin-turbo setup very nicely. If anybody has read my previous post here, i'm planning on twin turboing this 351 into a 600 RWHP daily driver on a mild boost setting. I've been told a custom grind cam would be good, any specifics as to who might do these?
I'm also well aware there are other aspects of the car that will not hold up, which I also need some advice on. In regards to the rear end, I'd think Eaton/Auburn is something I'm looking for. Are there any specific models for the fox body that's streetable? I'm not particular looking for a locker heh.
I've decided to use an aftermarket 351w shortblock with a forged rotating assembly to be the core of this engine. Just wondering in terms of intake manifold, cylinder head, camshafts I should use? I like the Trickflow Box-R Intake with the 13.3" runners with the AFR 225 heads which seems to compliment a twin-turbo setup very nicely. If anybody has read my previous post here, i'm planning on twin turboing this 351 into a 600 RWHP daily driver on a mild boost setting. I've been told a custom grind cam would be good, any specifics as to who might do these?
I'm also well aware there are other aspects of the car that will not hold up, which I also need some advice on. In regards to the rear end, I'd think Eaton/Auburn is something I'm looking for. Are there any specific models for the fox body that's streetable? I'm not particular looking for a locker heh.