hey who can tell me what this is?

wgpaintballer · May 2, 2006

I kinda broke this today and i dont kno what it is lol.. 1st what is is and do i need it?

795.0pacecar · May 2, 2006

I cant realy tell, the pic is too small.

wgpaintballer · May 2, 2006

click on it. its a attachment

xpeteyjtx · May 2, 2006

it's still kinda small. Atleast circle what you broke. Was it a vacuum line?

89Notch · May 2, 2006

Looks liek a wire connector, just follow the wires...

wgpaintballer · May 2, 2006

it seems to be a connection that has 4 wires and i ripped the one that goes to the EGR but it doesnt seem that i can only replace the one wire

dragnazz5.0 · May 2, 2006

it looks like a connector for all the vacuum lines that run the smog stuff and egr valve

ram360 · May 2, 2006

larger pic

bill302 · May 2, 2006

get one of these insulated male and female push on connectors and reconnect the 2 wires the one that pulled out and the wire directly across on the same pin from the wire that you pulled out..they can be purchased at any auto or department store....
View attachment 472497

legalize420 · May 2, 2006

get a piece of vacuum line and slide it over where you broke it and attach the other end to the egr.

Mustang5L5 · May 2, 2006

legalize420 said:
get a piece of vacuum line and slide it over where you broke it and attach the other end to the egr.

+1

bill302 · May 2, 2006

wgpaintballer said:
it seems to be a connection that has 4 wires and i ripped the one that goes to the EGR but it doesnt seem that i can only replace the one wire

i thought he said it was a wire?

legalize420 · May 2, 2006

bill302 said:
i thought he said it was a wire?

he did. they look like wires. the pic is small but i can still see whats circled.

Henceforward · May 2, 2006

They aren't wires they are vacuum hoses.

Buy replacement vac hoses at a parts store, and reconnect with fittings also sold at the store.

bill302 · May 2, 2006

well its either the egr vacuum hose or the evp sensor wire which is mounted on top of the egr....

302RollinHard · May 2, 2006

well from the picture it looks to me like it is an engine......Just kidding, a larger pic with references to what we should be looking at would be most helpful.

blackstangt · May 3, 2006

It's a connector for some vac lines, if you broke one, pull it out of the soft rubber, go to a parts store, get some line and replace. It is NOT electrical.

Roland69 · May 3, 2006

I made it bigger in my photo editing and it has 4 different colour wires

xpeteyjtx · May 3, 2006

Yea, go to a parts store and find some vacuum line that can slide over both ends. I bought some stuff that is 7/64" I.D. x 6 ft. (the 6ft. is negligable since the length of the line that you buy doesn't matter). It will fit over the old stuff pretty well. Those stock vacuum lines sure are ****ing brittle huh? I hate those things. Good luck.

By the way, I think those lines connect to the top of the intake, rear of the intake, then to each EGR valve solenoid... im not sure though... I dont remember. But they should be color coded, black and gray/white, so you will be fine

89white50 · May 3, 2006

How did you guys that took out the smog close those off? those are the vac lines that went to that rubber U shaped hose for the smog crap. I just plugged the ends and tapped it for now, but i was wondering if they sell caps to plug it off at where they go in to those small salt/pepper shaker looking things...

hey who can tell me what this is?

New Member

Attachments

lover of pudgy polygamists

New Member

New Member

New Member

My "0" key d0esn't w0rk, s0 I have t0 use the zer0

Active Member

Active Member

That is…until I whipped out my Bissell

Active Member

Active Member

The Avatar Master

Active Member

New Member

Member

Sergeant Tangnet

New Member

Member

Similar threads

Privacy & Transparency

Privacy & Transparency