Can someone post a pic of where they mounted them on the core support? I had read to remove the bump stop and mount them there. So i removed the drivers side and the hood sat to low. So im thinking the holes on the inner side of the bumpstops.
You can adjust the height of the hood pins by turning them and place some pieces of cut vacuum hose over the pins and then when you drop the hood down, the hose will keep the hood from rattling and also do the same function as the original bumpstops and raise up the hood level.
Are hood pins on a DD unnecessary? I'd like to put a black set on mine. I think it'd look sick with the bright orange and black pins.
I read if you have hood pins, it shouldn't see rain? I don't see an issue with a little rain going in....rain splashed up from below anyhow I'm sure.
Have you seen any rust or issues caused by water?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?