I put my stock hood back on last night and had trouble aligning it. I finally got it where it looked ok and closed it. Well, apparently it isn't aligned 100% because it doesn't come flush w/ the front bumper cover where the "ford" blue oval is. The real issue here is that the hood will not open!
I pull on the release lever under the dash and it does not do anything. I've pulled kinda hard and don't wanna pull much harder in fear of stretching or damaging the realease cable. The problem lies w/ the primary latch which is attached to the cable, of course, but it also could be related to the hood sitting about 1/8-1/4 inch too far back.
I'm at a loss here. I don't really want to drive the car unless I can pop the hood. Any ideas?
I pull on the release lever under the dash and it does not do anything. I've pulled kinda hard and don't wanna pull much harder in fear of stretching or damaging the realease cable. The problem lies w/ the primary latch which is attached to the cable, of course, but it also could be related to the hood sitting about 1/8-1/4 inch too far back.
I'm at a loss here. I don't really want to drive the car unless I can pop the hood. Any ideas?