horn problem

xexitenglishx

Member
Jun 27, 2004
153
0
16
Ok a few days ago my horn started to go off on its own. I didnt know this at the time and it had actually killed my battery. I jumped the car and didnt hvae a problem. When i honked the horn th wouldnt stop honking. Then the fuse blew. I put a new fuse in and it blew right away. I have a ford manual and it says to check the horn. I did that using a direct battery hookup to the horn. I couldnt get it to honk but i could get the wire to heat up very nicely. Would a blown horn cause the fuse to blow everytime now that the horn is honked? I checked teh connectiosn at teh steering wheel and they are working. I even checked the connection at the column by trying to short the horn to honk in the connection at teh steering column. No luck it just blew the fuse again. Anyone have any other input before i go out and buy another horn? thanks for your help.
 
Its actually pretty common for moisture to build up and cause the contacts to stick in our horns. Mine did it and I just relocated the horn to a button nearby. You may have heated up a wire and caused it to short out so now every time the horn tries to power up it blows the fuse.
 
The horns typically develop an internal short to ground, which causes the fues to blow. :eek:

The horns are located under the car on the driver's side, forward of the front wheel well. Disconnect BOTH horns, replace the fuse: if the fuse blows immediately, the problem is most likely in the cigar lighter circuit. If not, then press the horn button on the steering wheel: if the fuse blows the problem is in the wiring between the horn relay and the horn. If doesn't blow when you press the horn button, connect ONE of the horns and try again. If it still doesn't blow the fuse, connect the other horn. Chances are that the first horn you re-connect will blow the fuse. Whatever horn blows the fuse at this point has an internal short and is trash. Time for a trip to the junkyard... :crazy:
 
Ok thanks alot. I will do this testing over the weekend because i am at school now. I know its not the steering wheel bc i have tried to activate it furtehr down the line. Now i must disconnect the horns. If i disconnect one do i have to connect the hot line or are both the connection hot. I other words are tehy dais chained or they bothhave a hot line running to them? Thanks
 
i had the same problem. horn testED fine, but whenever i hit the horn it always blew my fuse. i took off my fender and replaced both horns ($12x2=$24 total) hooked up both horns and it works awesome now. no more fear of driving without a honker! i got a high freq and low freq horn so everyone can hear me. its hella LOUDDDD!!!
 
xexitenglishx said:
Ok thanks alot. I will do this testing over the weekend because i am at school now. I know its not the steering wheel bc i have tried to activate it furtehr down the line. Now i must disconnect the horns. If i disconnect one do i have to connect the hot line or are both the connection hot. I other words are tehy dais chained or they bothhave a hot line running to them? Thanks
Only one wire per horn. They ground the metal horn shell to the body.
 
as was mentioned mine were basically glued together as the fabric between the 'plates' wore down. Take the button totally apart and you can see it. I am in the process now of getting new material to put in between the plates and she should be as good as new. In the meanwhile I was finally able to get another button for her :)