How do I se the TPS voltage?

[Venom_Nitrous]

I think mine is fudged up, ever since my 75 mm TB went on. The Nitrous has a wot switch but mine comes on at half throttle. Haven't used it because of that. J/w what to do, I took mine off and when I shake it it makes a rattling sond so I got a new one.

 

[sgramer]

It should be around .95-99, but not above 1.0 volts. The is a adjustment for the throttle plate, and it also adjusts the tps.

Use the center wire, and the ground wire to set the voltage. The other wire will have a 5 volt signal on it. The use the adjustment on the side of the TB.

Scott

 

[tomustang]

get a multimeter and start poking around

 

[r0ck3r]

make sure you don't twist the tps sensor the wrong way. my friend did that and own3d mine

 

[Venom_Nitrous]

It should be around .95-99, but not above 1.0 volts. The is a adjustment for the throttle plate, and it also adjusts the tps.

Use the center wire, and the ground wire to set the voltage. The other wire will have a 5 volt signal on it. The use the adjustment on the side of the TB.

Scott

Is that closed or at WOT??

 

[jstreet0204]

Is that closed or at WOT??

closed, should be < 1 volt
WOT around 4.7 volts

 

[CanadaStang]

Another test you can do is to use an ohm meter and probe the terminals [the terminals on the TPS, not the wires] on the TPS that correspond to the brown/white and grey/white terminal wires [I think thats right,if memory serves correctly] Slowly rotate the throttle shaft and monitor for a continuous, steady change in resistance. Any sudden jumps or irregularities in resistance indicates a malfunctioning sensor.

 

[Darkhorse845]

It should be around .95-99 .