yes. It is unclear why it was bent. The number 7 intake air was bent, so I replaced it. Is there a lack of oil pressure because it hasn't been moving for a long time? Fixed? Currently there is compression.This car is an original with 10000 miles and you had a bent pushrod??!!
The engine is original.Ok so we noticed you replaced a lot of parts. Engine completely stock? You arent running a "chip" are you?
It's not a MAP sensor but a BAP sensor, but today I tried applying pressure with a hand vacuum tool.Mass Air Car? Is the BAP hooked to a vacuum source?
BAP sensor.You didn't answer the question. Is there a vacuum source running to the BAP sensor on your Mass Air car?
MAF sensor has been replaced. This is a BAP sensor vehicle.You can just see the MAF in the last video the OP posted. With that there should be no vacuum attached to the BAP sensor.
And just to be clear to the OP this is the BAP sensor
This is the MAF sensor
This is a mass air mustang...MAF sensor has been replaced. This is a BAP sensor vehicle.
The gasoline is new. The unstable idle has been fixed. It emits black smoke. The gasoline runs out quickly, so I'm constantly adding new gasoline. I removed the O2 sensor and installed an air-fuel ratio meter, and the reading is rich.This is a mass air mustang...
Anyway im curious about this "has not been run in awhile" did you use fresh gas?
This is a 1991 kit car. Is the ECU tag the part number?Can you get a picture of the data tag on the ECU and post it?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?