i am stuck on me next upgrade

I would definately get some new lower control arms, especially if your going to be replacing the uppers. Not only will you save yourself some time by installing them together, but the stock lowers definately do not support good traction. You'll need both for a good setup.

Since you already have the upper control arms, Ide just get the lowers and wait on the x-pipe. Although an x-pipe will give you more top end power, and a better sound, its not going to improve matters on traction. As stated before, since you got the uppers, get the lowers and be done with them. Then, worry about an x-pipe.

If youre going to mess with headers, I recommend LT's. Short tubes on a n/a 4.6ltr will probably be a waste. Headers are expensive and if youre going to spend the time and money to mess with your headers, I recommend LTs for best power gains for the dollar over short tubes.

EDIT: Should you decide to go with LT headers, hold off on the x-pipe and then when you decide to get the LT headers, just get a matching x-pipe then.

if you buy LT Headers...dont you have to get a short x pipe?

DaDDyGSp0T said:

if you buy LT Headers...dont you have to get a short x pipe?

Click to expand...

Yes, or you can have one meant for short tubes cut down and modified to fit. Of course, thats a crappy way to go to. Its best just to have a matching x-pipe that will fit perfectly without any cutting and welding needed.

Dark Knight GT said:

Yes, or you can have one meant for short tubes cut down and modified to fit. Of course, thats a crappy way to go to. Its best just to have a matching x-pipe that will fit perfectly without any cutting and welding needed.

Click to expand...

i would just get the shorty headers then

stanggt00 said:

woot thxs man for the fast reponse i will complete the rear-end then with the lower control arms but do i need adjustables or no i got a good deal on the upper adjustales from jdperformance

so i will just follow up with subframes once the arms are done and start saving for the lt headers and matching x-pipe

Click to expand...

If the uppers are adjustable, then solid lowers should be fine since you adjust your pinion angle with the uppers, not the lowers. Ide only get adjustable lowers if I was building a super serious track car.

stanggt00 said:

guys are adjustable lowers a must have or are they just as good as standard non adjustables

ps the car is a daily driver and weekend warrior

my goal is traction first,power second and then looks

so my next few mods will be
subfames
lt headers/x-pipe
procharger

then
strut tower bracers
sway bars
k-member

Click to expand...

As I stated in the last post, Ide only get adjustable lowers if I intended to turn my car into a serious track car. Even then, it might not be necessary.

The list you have looks pretty good. I might say adding a dyno tune in there after the procharger and exhuast mods might be a good idea.