• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-

I got a 1990 Mustang GT crank problem I think

  • Thread starter Thread starter naildriverinnc
  • Start date Start date Mar 7, 2008
N

naildriverinnc

New Member
Sep 30, 2007
7
0
0
Mar 7, 2008
#1
  • Mar 7, 2008
  • #1
I got a shimmy and a shake in the car it's not the harmonic balancer or the flywheel. Does anyone know how the car would act if the crackshaft was bad or could this be the cause of my shimmy and shake
 

LiquidGT

Member
Oct 8, 2007
368
0
16
Near STL hell
Mar 7, 2008
#2
  • Mar 7, 2008
  • #2
Dou you think it could be the driveshaft?
 

mustangfan1990

New Member
Jul 17, 2005
505
1
0
Lenoir, North Carolina
Mar 7, 2008
#3
  • Mar 7, 2008
  • #3
I know my crankshaft was bad it caused my harmonic balancer to keep going bad....Dont know if that applies to you I just know that what happened to me
 

ttop88

Member
Mar 12, 2007
42
0
6
indiana
Mar 7, 2008
#4
  • Mar 7, 2008
  • #4
Shake all the time? Any noises? Crank is very unlikely. Drive shaft, u-joint or bearing is most likely.
 

Darkwriter77

Resident Ranting Negative Nancy
5 Year Member
Jul 1, 2005
314
281
134
Apache Junction, AZ
Mar 7, 2008
#5
  • Mar 7, 2008
  • #5
Is it only while the vehicle is in motion, or while it's sitting still? Does it do it at any speed, or just at a certain speed and higher? Can you see the harmonic balancer wobbling? Is there a clunking/knocking sound coming from the lower end of the motor?
 

mustangfan1990

New Member
Jul 17, 2005
505
1
0
Lenoir, North Carolina
Mar 7, 2008
#6
  • Mar 7, 2008
  • #6
If it does it no matter what I would say harmonic balancer
 
N

naildriverinnc

New Member
Sep 30, 2007
7
0
0
Mar 8, 2008
#7
  • Mar 8, 2008
  • #7
I replaced the harmonic balancer with the original 50oz the rubber seal was pushing out of it. And yes when it's at an idle it's not as bad but when you give it gas it's real bad. It's a 5 speed it shakes in gear and out of gear so I ruled out the drive shaft. It kinda feels like the driveshaft is bent and when your sitting in the seat give it gas feels like it's gonna come through the floor board
 
N

naildriverinnc

New Member
Sep 30, 2007
7
0
0
Mar 8, 2008
#8
  • Mar 8, 2008
  • #8
On the pm I got no there is no lose of power at all
 

Darkwriter77

Resident Ranting Negative Nancy
5 Year Member
Jul 1, 2005
314
281
134
Apache Junction, AZ
Mar 8, 2008
#9
  • Mar 8, 2008
  • #9
So, you're saying it vibrates in or out of gear, either while moving or while at a standstill, and the vibration coincides with RPM's, correct? That pretty much rules out anything from the tranny on back, then, so at least you've narrowed it down to something with the motor. I still doubt that it's the crank, itself, though.

Even though you replaced the balancer before, have you looked at it to see if it's still wobbling? It's possible that you got a defective one, or that it may have been installed incorrectly/damaged during install (it happens).

Only other thing I can think of is, being that it's a 5-speed, is that your flywheel may be out of balance somehow. Either one of the tack-welded weights might've come off somehow, or it may not have been properly torqued down if/when it was last serviced, and so it's wobbling like mad. Do you have any vibration in the clutch pedal?
 

BLOWN 5.0 FOX

Member
Apr 4, 2005
213
0
16
NORTH SHORE MA
Mar 8, 2008
#10
  • Mar 8, 2008
  • #10
hows your motor mounts??
 
N

naildriverinnc

New Member
Sep 30, 2007
7
0
0
Mar 8, 2008
#11
  • Mar 8, 2008
  • #11
Motor mounts are good
 
N

naildriverinnc

New Member
Sep 30, 2007
7
0
0
Mar 8, 2008
#12
  • Mar 8, 2008
  • #12
I'll check to see if I the balancer is wobbling and the clutch pedal for a vibration tomorrow. I had the flywheel off to check it and it looked good.
 

5.0Droptop

...all those nights we shared, and you're a dude??
Special Agent Mukity-Muck Whats in Charge Round Here
May 15, 2002
1,785
1,130
233
Indiana
Mar 8, 2008
#13
  • Mar 8, 2008
  • #13
Has this engine been rebuilt? If so was it a 28 oz balance or 50 oz balance? If its a 28 oz balance and you put a 50 oz balancer on. It will shake.
 
N

naildriverinnc

New Member
Sep 30, 2007
7
0
0
Mar 9, 2008
#14
  • Mar 9, 2008
  • #14
No you can't feel it in the clutch and the harmonic balancer ain't wobbling. It's got a new 50oz balancer on it i installed a new one and the flywheel is also a 50 oz.This is all the guy I bought it from had done to it NEW 5.0L CRATE ENGINE W/ GT40 HEADS AND VALVE TRAIN
- NEW NEW WORLD T-5 TRANS AND SHORT THROW SHIFTER
- NEW 3.73 GEARS
- NEW HIGH PERFORMANCE FORD
MOTORSPORT CLUTCH
- COBRA INTAKE AND 70MM THROTTLE BODY
- COLD AIR INTAKE & UNDERDRIVE PULLEY'S
 
You must log in or register to reply here.

Similar threads

M
85 mustang 5.0 cranking in run position
  • Mamaclean
  • May 23, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
3
Views
140
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jun 1, 2026
General karthief
G
New Owner: Very Clean 1991 GT Convertible. All original with 21k original Miles. How to make it better?
  • gvanginkel403
  • Oct 30, 2025
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2
Replies
31
Views
1K
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Nov 17, 2025
Jarhead67
J
1990 Mustang with no-start condition - Fixed and how-to
  • TTSaleen
  • Mar 22, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
0
Views
126
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Mar 22, 2026
TTSaleen
K
Severe Drivetrain Shaking
  • KeithM412
  • Jul 5, 2025
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
6
Views
297
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jul 29, 2025
AeroCoupe
P
2002 T5 transmission vibration issue
  • puffoo
  • Feb 22, 2026
  • SN95 V6 Mustang Tech
Replies
0
Views
180
SN95 V6 Mustang Tech Feb 22, 2026
puffoo
P
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?