• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

I need help with Timing

  • Thread starter Thread starter neil_home
  • Start date Start date May 28, 2007
N

neil_home

New Member
Jan 2, 2002
37
0
0
Connecticut
May 28, 2007
#1
  • May 28, 2007
  • #1
I have what I thought was the Duraspark III but during the search I read someones note with a part number the same as mine that was called the Duraspark II. Anyway it is a 5.0 with the crank trigger. There is a fixed (not adjustable) distributer with just the rotor inside. I thought from the reading I had done that the adjustment for the rotor may change the timing. My emmisions were just a hair high on the HC and CO. I did a tuneup,air fiters. and fixed a hole in the air pipe going to the cats. I checked for vacuum leaks and filled it with high test gas. It failed exactly the same way. Just a tad high on HC and CO. The readings on this car have been the same for years. The limits are lower.Its an 83 5.0 TBI.Does anyone know how to adjust the timing. It idles at 20 degrees advanced. I read it should be 10 and that that might put me under on the emissions. If you know how to adjust this or have any other ideas please let me know.

Thanks in advance, Neil
 

91 HATCH

Banned
May 17, 2007
262
0
0
illinois
May 29, 2007
#2
  • May 29, 2007
  • #2
if the rotor is adjustable it will change the timing if you adjust it
 
N

neil_home

New Member
Jan 2, 2002
37
0
0
Connecticut
May 29, 2007
#3
  • May 29, 2007
  • #3
Timing

The rotor change did not change the timing. It is at 20 degrees. Moved it both ways and rechecked no change. Then disconnected the battery and adjusted again. No change. The book says it onlt needs adjusting to make sure the spark is in the correct position in the cap. I can't find anything else adjustable. On the car or in the books.
 

91 HATCH

Banned
May 17, 2007
262
0
0
illinois
May 30, 2007
#4
  • May 30, 2007
  • #4
i think the springs on the weights for the mech. advance in the distributor are bad they should be cheap at a ford garage
 

93 LX

Founding Member
Jun 2, 2000
3,081
3
0
Norwalk, CA.
May 30, 2007
#5
  • May 30, 2007
  • #5
to start a duraspark 2 is a carbed car or TBI right? Even if the crank sensor does not move then the distribtor has to move. Also you have to have some sort of advance system, did you set the timning with out the vacuum advance hooked up?
 
N

neil_home

New Member
Jan 2, 2002
37
0
0
Connecticut
May 30, 2007
#6
  • May 30, 2007
  • #6
93 LX said:
to start a duraspark 2 is a carbed car or TBI right? Even if the crank sensor does not move then the distribtor has to move. Also you have to have some sort of advance system, did you set the timning with out the vacuum advance hooked up?
Click to expand...


The car is a TBI. There is no vacuum advance. I did not notice any mechanical advance in the distributer either. The distributer is keyed and will not move. The crank pickup looks like it is stationary in the front cover. But I couldn't see it very good (air pump in way). The timing ring looks to be pressed on the vibration damper. I can get the part # of the ignition box if that would help. I am at a loss for ideas.
Neil
 
You must log in or register to reply here.

Similar threads

8
Engine Rough idle and aggressive sputtering when accelerating
  • 88vertible
  • Aug 13, 2025
  • Fox 5.0 Mustang Tech
Replies
4
Views
1K
Fox 5.0 Mustang Tech Dec 13, 2025
Jarhead67
J
9
I just put a new engine in need help with setting timing through mega squirt tuner Studios.
  • 90 LX Vert 347 MS
  • May 23, 2025
  • Digital Self-tuning Forum
Replies
2
Views
293
Digital Self-tuning Forum May 24, 2025
Glliw
G
Engine 1990 LX 5.0L EFI Mustang Fuel Management Problems - HELP!
  • 5.0LXStanger
  • May 25, 2025
  • Fox 5.0 Mustang Tech
  • 2 3
Replies
45
Views
3K
Fox 5.0 Mustang Tech Jul 11, 2025
5.0LXStanger
6
Hey all,I’m putting together a 302 for my 1968 Mustang and wanted to post the combo + some questions to make sure I’m not missing crucial
  • 68_Disgustang
  • Feb 22, 2026
  • 1965 - 1973 Classic Mustangs -General/Talk-
Replies
5
Views
1K
1965 - 1973 Classic Mustangs -General/Talk- Oct 19, 2026
mattcrp1
M
S
Help with window and possible engine
  • StefRena22
  • Jun 12, 2025
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
19
Views
1K
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jun 21, 2025
Willybill32
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?