I need some lowering blocks STAT!!

[Rent-A-Racer]

Does anyone have some 1.5-2 inch lowering blocks they would like to sell? I need some for my 9'' ford rear-end and I don't want to buy $25.00 worth of U-bolts that I can't use. I would be eternally grateful

 

[HistoricMustang]

I have a 1" set of aluminum lowering blocks that you can have. Not a believer in aluminum as they may stress and fail. Mine are the infamous "plastic" ones that have been discussed here before.

Send me a PM if you want the ones I have.

HistoricMustang
www.historicmustang.com

 

[Rent-A-Racer]

yes I would like them. my e-mail is [email protected]. Please email me with the details

 

[HistoricMustang]

"Rent-A-Racer", I sent you a PM. You will have them N/C in 7 to 10 days.

They are aluminum so check for stress cracks every so often.

I will get the info up on my "non-stress" plastic units in the next day or two.

Good Racing,

HistoricMustang
www.historicmustang.com

 

[Rent-A-Racer]

Thanks alot! LMK when you have some info on the plastic ones! Do you produce these yourself?

 

[pabear89]

"Rent-A-Racer", I sent you a PM. You will have them N/C in 7 to 10 days.

They are aluminum so check for stress cracks every so often.

I will get the info up on my "non-stress" plastic units in the next day or two.

Good Racing,

HistoricMustang
www.historicmustang.com

If you using the block that i think your using,
It's not "plastic" but a Teflon.
Harder than plastic but not as brittle.

PB

 

[HistoricMustang]

pabear89.........Teflon is closer than plastic. I will get the correct name and a pic up in a day or so. Trust me, it is not a hard plastic.

HistoricMustang
www.historicmustang.com