I Want To Be Like Groverdill. Give Me Your Thoughts

[Noobz347]

Yeah... My little plan is HCI power only.

 

[Chuckman]

Eh, I think I'm gonna run 30s with my combo anyway. I would like to go power adder too.

Actually, just debating selling off all my Windsor stuff and going Coyote.

/hijack. Carry on

HCI 5.0 > Coyote. By a lot. Coyote may win peak power, smoothness, and rev happiness but sbf is simpler, less expensive, broader power band that actually has some low-end torque, and sounds waaaaaaay better.

 

[mikestang63]

can that be done?

(Scratching head and looking at MAF conversion I am about to put on)

yep. unless you install a bower or a cam with a huge lift that will not allow the SD EEC to compensate, you can do an HCI. I did that about 20years ago with an SD friendly Crane cam and Edelbrock 6037 heads before I put on the Vortech and then went MAF and swapped the cam.


IF you want to keep it SD, Mike Post or Chris Johnson can probably burn you a chip. Chris when he was JMS did one for me back in the day..

Now back to my friend @nooobz347.. Trust me... I would love to throw a set of 11r heads and an FTI cam on it.. but even keeping it SD I would need the throttle body, headers, H Pipe,, intake, etc etc... Still around $2000-$3000 .... unless I do the GT40 route and then its$1500 but I like to do it once and done.. hey..... STOP PUTTING THESE THOUGHTS IN MY MIND....

must keep it stock
must keep it stock
must keep it stock