I have had an IAC restrictor plate on my car for a couple years and it worked great. I just installed an Accufab 75mm TB and Plenum. I made sure to remember to transfer the plate over during the swap. Now I am back to the hanging idle issue. Is anyone else running this set-up? It has been so long since I installed it the first time that I can’t remember; does it take a while for the computer to adjust to the plate? I think it might be getting a little better but can't tell.
IAC Restrictor Plate (I Searched)
- Thread starter comporange04GT
- Start date
BennyBlown2v
New Member
Did you reset the computer by disconnecting the battery during the install? Just disconnect the battery then leave it for a while and go eat lunch or something, reconnect, then go drive the car for 30mins or so! Doing all this will insure that it resets and the computer "relearns".
Similar threads
