Im going to attemp it..

Well since my car has been doing the one wheel peel, i figured this winter would be the perfect time to do the trac lock rebuild. I searched and heard some people say its hard and some said its not to bad. Now i have a decent amount of mechanical knowledge and many special tools, like verniers and all kinds of things i got from my dad.

Should I attempt this, I feel if i have some directions and the right parts I should be good.

Also, i heard you need a special tool, but what is that tool:shrug:

Any input appreciated, thanks guys
 
-jackstands
-remove wheels
-remove drums(or disc)
-Pull diff cover
-drain stank ass fluid
-take 5/16 bolt out that holds the cross pin in.
-remove croos pin
-push axles in toward center of car
-remove c-clips from axles ends
-pull axles out and inspect for bearing wear at end near lug flange
-remove 4 bolts on the u-shaped carrier's on either end of the diff.
-keep bolts and spacers..SPECIFIC TO SIDE.(left to left and right to right)
Some one take it from there.
Or head to junk yard and find 87-88 turbocoupe rearend and replace your with it.Comes with fords limited slip (manual 3:55 Auto 3:73)and rear disc brakes.
 
job is not hard at all... just make sure you keep your clutches and steels in the right order, some like to lube clutches but I feel it makes life harder than it should its all personal preference really. The hardest part of the whole job is getting the S spring back in and you will find thats not that hard either. Good luck!!!!!!!!
 
its easy I say go for it. If you remove the carrier from the housing be sure the shims go back in the same location (right side/ left side). I have herd of a few people who dont remove the carrier assy to do the rebuild but have never tried it.
the stock fiberdisc/steeldisc configuration can be modified to increase capacity. I have done this it is easy and effective. the revised clutch packing sequence is (from side gears out) friction disc, steele,friction disc,steel,friction disc, steel,friction disc then the shim. This gives you four friction discs per side instead of three. Be sure to soak the friction discs in friction modifier fo 20 mins or so.

Chris
 
cool, thanks alot guys, sounds like i could do it ok. Once i start it later on this winter, if i have anymore questions, ill be asking. But i read over some previous posts about it and i seemed to get the gist of it. Thanks dudes:nice: