In need of a better spacer

Hi

I have the same problem with my 18X9 deep dish bullits from mustang tuning with steering wheel shake between 55-65 mph I also have the universal 1/4 inch spacer in front. I wasn't thinking the spacer was the problem? that maybe they still are out of balance, I'm going to take my car back and have them pull the two fronts off and rebalance them again to see if that solves the problem? If it doesn't then I will go the route you are by putting on the spacers that have the actual correct bolt patterns for Mustangs. My suggestion would be to try Pep Boys I hear they carry more options then just the universal spacers.

Good luck

Did you remove the retaining clips from the rotors? There will be one on each around a single stud. Remove that- it is only there for the factorys' uses.