Inertia Switch... HELP!

rustang87

New Member
Apr 1, 2005
70
0
0
Sac
Is the inertia switch in the passenger Kick panel? I kind of droped the frame on to the jack stands a little fast... Now it will run... for a minute then starve and die... I also hit the FP cutoff in the trunk to reset it and it made no difference. I got the code 95, but that comes up when you convert from Speed density anyways... HELP! Any ideas...
 
Aaron is right. I would probe the fuel pump relay with your meter and note the values you get with:

The car off
and
The key on and pump priming.

Knowing what you are missing will help to get you up and running (the FP relay socket is like a 4 way stop in a road. Knowing what is absent tells you which road to travel down).

Good luck.
 
Is the FP Relay that black box? What should the volt meter read if it is working properly? Key on engine off? I am clueless and very frustrated... Please spell it out for me... Thanks for the responce.
 
rustang87 said:
Is the FP Relay that black box? What should the volt meter read if it is working properly? Key on engine off? I am clueless and very frustrated... Please spell it out for me... Thanks for the responce.
The FP relay should be under the driver seat on your 87 (unless a MAF conversion from a 92+ donor vehicle moved the relay to the passenger side strut tower area).

With the key off, you should see one wire with 12 volts and the others are dead.
WIth the key on and priming, you would see 3 wires with 12 volts and one with ground.

And if there is an issue, then it will be some variant. Knowing what you actually see will tell us what to have you hunt down.

It should not be too hard to sort out, so dont get too frustrated. :nice:

Good luck.