injectors to big?

brian_23456

New Member
Apr 6, 2005
50
0
0
I am planning on putting a paxton novi 1000 with a Anderson powerpipe on my GT, and was looking at a used set of injectors. Would 50# injectors be too much if I plan on using the pulley that comes with the kit? I know most poeple use 42# injectors, but I would rather get these used ones if I could.
thanks
 
A set of 36lb injects would be more than enough for a Novi 1000's flow potential and keep things cleaner/smoother down in the lower RPM and at idle too. Sometimes bigger isn't always better my friend. Let these 50lbers go and mate that Novi up to a properly matched set of injectors.
 
No, 42's are not too much injector, but still overkill for your Novi needs. The rule to follow as far as injectors are concerned is using just enough to keep them within efficient operation range is best. You don’t want to see much more or less than 80% duty cycle which is what you’ll achieve at 330-380hp with 36lb/hr injectors (about where the Novi would put you with a few minor bolt ons). Any smaller injector may overwork the injector and with much more that that small things like emissions, idle quality and low end response suffer. 36's would work best, but 42's aren't that tremendous by comparison and will prove nearly as good in all but the most severe conditions (like high temp/humidity and elevation levels).