Installed an S-trim on a 94 Cobra and have some questions...

I bent mine with my hands, and no it wasn't easy-it needs to rest right against the radiator hose when it is installed. As far as mounting the MSD box, I put it on the black plastic firewall piece behind the upper intake-thats about the only place that it will fit. I just finished up an s-trim on my 95 cobra (all stock except for exhaust and 3:73's) so it is the same difference. Right now, I am running the fmu with 12:1 disk (upgrading to larger injectors and MAF later on) instead of the called for 10:1. I was running too lean on the dyno with the 10:1 so make sure you get on a dyno before getting into boost!!

If I read this right the kit should have came with a connector/coupler for the radiator hose. I know it had to be cut and and then it re-routed at the correct angle.

RIght here:



Helps keep it a bit cooler
RC

I kept my oil cooler lines, had to cut some off of the one going down to the oil filter to get out of the way of the altenator-it can be done, just takes some time to figure it out. I also had to go out and buy some more heater hose because there wasn't enough in the kit to meet my needs.