Installed Maximum Motorsports clutch cable package

I went with the MM clutch cable package Part# MMCP-51 which included 1) Universal clutch cable, 2) Firewall adjuster, and 3) Quadrant. My first clutch cable install went ok. This is my 3rd kit with the first two lasting not even a year each before snapping(Don't know what kits they were since I had a shop install them during a tranny rebuild and second time when installing some other new parts). I did many searches through here to see how the install went with othes and to get some pointers before I tackle the project. Hardest part was taking off the previous cable and installing the new quadrant onto the shafts(lining up with the 2nd shaft). I did have to make a run to Sears for a round file to enlarge the hole on the firewall for the FWA.

Reading through some of the searches, the only thing I found confusing at first were the terms of "engaging" and "disengaging" and what it actually meant to the person installing their own kit. I did find out through testing to rotate the FWA counter clockwise to the point where the clutch pedal is about 2-3" off the ground before the clutch "engages" and car starts rolling. If I tried rotating the FWA clockwise, it is harder to engage into the gears. Seems like I have a little more adjustment if needed to rotate more counter clockwise, but I love the feel right now. Shifts like butter and the pedal feel is real light compared to before. Now if just need to get my AC fixed because having black cars in W. Texas with 3 digit temps up to 110* is not fun.


Here are some pics below with a few questions I may have.



Here is the previous kit and it looked as though the cable came off track and starting rubbing against the quadrant for some time before snapping.
View attachment 313542

Off topic, but is this the door chimer?? I just removed this underneath the dash so I can get access with my left arm in removing/installing the old cable and quadrant. I notice it was unplugged already where you can see on the right side of it the prongs exposed.
View attachment 313543

Ok, here is the end of the cable attached to the fork. Question, if later on in the future I run out of adjustment room on the FWA(Unable to rotate it counter clockwise anymore), would installing some nuts or spacers between the fork and tip of the cable allow for more room on adjustment? I notice somewhere somebody mention something to that effect. It would just be a matter of how. Tips or suggestions for future reference?
View attachment 313544
View attachment 313545

Next is putting the Fiore setup in the cobra. The FWA and Quadrant. Can't wait!

After getting the stang running and finally washing for the first time in 2 months, it starts to rain

Kumm3 said:

I had the same issue with mine, i ended up mounting it to the front of the cylinder head. Made the overall radius of the bend of the clutch cable to be as wide as possible.

Click to expand...

I forgot to mention I had this same problem just like Swede958 mention with the metal bracket on the cable too far from the original cable location. I have to get under the hood again and look for another location for a wide angle for the cable. I may try the cylinder head location too if it work great for you.