Installing headers this weekend

I am installing a set of BBK shorty headers into my 1992 LX mustang. Does anyone have any kind of inside tips or info to share? I am trying to go through this without any problems. I have just the stock ones on there right now and I have heard many horror stories about bolts snapping and whatnot. I appreciate in advance any info that you guys would like to share. Thanks in advance!
 
94 Cobra 5.0 said:
pb blaster is your friend. spray all the bolts the night prior to allow time for soak in and spray them again before you go to pull them off.
:stupid:
Don't worry about the bolts breaking at the head. It is usually the studs on the collector end but that doesn't matter because you have new headers. Also don't use cheap paper gaskets, use the metal ones.
 
i have the flowtech LT's on my car. the LH side is not thats hard to put in ir remove. the RH side is the one i hate. It comes apart in 4 pieces before it come off. But i have had alot of start probs so i have it down pat now!!!:nice:
 
When I did mine, I took the front tires off. It just made it so much easier to get around under the car when it was up on jacks. Just be patient w/ the rear bolts, esp. on the passenger side, they're kind of tough to get to.
 
I pulled the intake hose off along with the rubber smog hoses on the passenger side when I installed shorties on my '89 GT. Liquid Wrench was handy, but I didnt break any collector bolts. I didnt pull the wheels off or lift the engine either. Might have been easier if I did, though.