Installing sway bar end links...

[click]

Hey i broke my driver side end link, and i ordered new ones from mustangparts.com and i was wondering how to install them. It says you can't jack it up and that the wheels have to be on the floor. That will be freakin hard to get under the car without it being jacked up. How would i go by doing this. Are there any tips to install new end links or is it pretty simple and self explainatory?
TIA

 

[2L8ULUZ2]

It can be done without jacking the car up. All I done was turn the wheel so it is all the way to the outside of the side that I was working on and changed the end links out and then done the same for the other side. It took about 10min per side to do them and that was it.

 

[94-302-vert]

HUH?

I dit it wth my entire front end hangign as it was on jackstands...

Mine were jsut about welded on but a nolle bit of heat and some penetrating oil to cool it down and it came apart no problem. the worst part was getting it up in the air.

while you are at it you may as well measure the bar diameter and then get soem new poly bushings for the bar too.

Chris