Intake Spacer

I have a GT40 Upper and lower intake, recently had to remove the upper and replace the space as it was wearing out from years of heat damage and minor cracking that was causing a vacum leak. I replaced it with a new BBK spacer, but now my throttle cable bracket will not fit back properly. I know I could cut the bracket as many people do, but I don't want to.

My old spacer was 3/4" thick, the new BBK is 3/8" thick. I have looked at cannot find a 3/4" spacer anywhere, but I see that Trick Flow makes one that is 1" thick. Will the 1" spacer fit under a stock hood? Anybody using the same setup? It was tight before with the 3/4" spacer. I also have the FRPP stamped aluminum valve covers, which are taller and why the bracket will not fit.

And one last thing someone gave me another 3/8" spacer for a GT 40 type intake, but it does not have a hole in the center like mine does. What is this off of, Cobra? I see some Cobra intakes with the center hole.
 
I had a 1" spacer and I could close the hood but it rubbed the underside in a few spots. The best way to check to see if it will clear is to take some playdough and put a big wad of it on the parts that you think will hit the hood. Close the hood and then open it back up. Measure the thickness of the playdough and you have a pretty good idea of your clearances.
 
my 3/8 bbk spacer didn't come with the egr hole drilled in the center, I had to drill out a hole.

I have a stock throttle cable setup, but it bolted on just fine.
 
I drilled a hole into my BBK 3/8" spacer too.

If you ever want to block it off again, take a razor blade, slide off the fat end and rtv it down to the intake and then slap all the gasets on.
 
Like I said before I used to have a 3/4" spacer and it fit fine. But I know when I bought the car it had a pushed up ding in the hood from where it looks like the hood hit the intake. Don't know if they tried to use a 1" spacer or not I have owned the car for 13 years now. Just wish I could find another 3/4" spacer. I am thinking about trying my extra spacer with the current 3/8" spacer, I think with the gaskets it will be close to 3/4". I will use 3 gaskets instead of 2.

Do you think that would seal right?
 
I think that it would seal fine. I would give it a shot. The worst thing that could happen is that it wouldn't seal well and you would have to use the 1" or modify the throttle cable bracket. No harm in trying the 2 spacers together.