Intake swap

95mustang_gt said:

Well im about to switch my intake to a 93 cobra intake.I know i have to do the fox tb swap.I am just wondering what tools i need?I have all basic tools.Do i need any special tools?what should i have with me?

Click to expand...

search around..you dont need to run the fox conversion...an elbow will work if your so inclined...recent post on that one...

Fuel disconnect tools for the lines at the intake for one...3/8 drive TQ wrench would be good...1/2" drive is a tad over kill and may not give you accurate readings...otherwise just normal tools...
I would round up some 1/4x18 or 20?x2" long allen studs (4) for setting the lower, (1) at each corner...lines it up nice and even..
Gaskets....I like the Fel-Pro MS93334 myself for the lower, you'll need the Cobra upper to..Fel-Pro MS95953

The Grn/Yel set works good...