• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Intermit Stutering losing spark

  • Thread starter Thread starter mapoff
  • Start date Start date Oct 10, 2005
M

mapoff

New Member
Sep 15, 2004
19
0
0
Blacksburg, VA
Oct 10, 2005
#1
  • Oct 10, 2005
  • #1
Help I'm going to pull the trigger.

Out of the blue the car started stuttering as if more than 1 cyclinder was not getting spark intermit. all driving ranges. i replaced the coil. no go, checked power going to the coil and it randomly drops out at the same time it stutters.

could a loose timing chain be the cause. isn't there a "hall effect" sensor that tells the computer when each cyclinder is tdc which. the ground on the battery was slightly loose, i tightened that and didn't notice it for a day. next day same thing. i have new

cap
rotor
plugs
plug wires
coil
air filter
ignition module
 

sgarlic

Founding Member
Apr 21, 2001
3,085
1
56
Oct 10, 2005
#2
  • Oct 10, 2005
  • #2
Yeah, the PIP inside the dizzy has been known to cause sputtering, no-start conditions (including the one I'm troubleshooting on my '88 currently.)

By ignition module I don't know if you mean the TFI, or the ignition switch, but the TFI module also has been known to overheat and cause stuttering, etc.
 

HISSIN50

"How long does it take to get help in here?
15 Year Member
Nov 29, 1999
31,179
34
129
Oct 10, 2005
#3
  • Oct 10, 2005
  • #3
As Andy said, the PIP is very possible.

Down and dirty test: put your inductive timing light on each plug wire and hit the trigger. Note any cylinders which dont have a constant nice spark (indicated via the timing light pulse).

A cylinder balance test could be very revealing if you can run tests while the car is hiccup-ing.

Good luck.
 
M

mapoff

New Member
Sep 15, 2004
19
0
0
Blacksburg, VA
Oct 12, 2005
#4
  • Oct 12, 2005
  • #4
Pip?

Well you can only tell when your going down the road, hot and cold, high and low rpms. i did replace the thick film module. i do not know what a pip is.

another piece of info, when it goes out the pwr to the coil goes out, and more than 1 cyclinder in a row misses. it all happened immediately. something is def going down electronically. i hate stupid problems like this that aren't in your face.
 

jrichker

StangNet's favorite TOOL
In Remembrance. Thank you for your contributions
Mar 10, 2000
27,512
2,813
234
Dublin GA
Oct 13, 2005
#5
  • Oct 13, 2005
  • #5
mapoff said:
Well you can only tell when your going down the road, hot and cold, high and low rpms. i did replace the thick film module. i do not know what a pip is.

another piece of info, when it goes out the pwr to the coil goes out, and more than 1 cyclinder in a row misses. it all happened immediately. something is def going down electronically. i hate stupid problems like this that aren't in your face.
Click to expand...
The pip is the sensor is in the bottom of the distributor that triggers the TFI. You have to press the gear off the distributor shaft to get access to it to replace it. Most guys just end up replacing the distributor with a reman unit for about $75 exchange
 
M

mapoff

New Member
Sep 15, 2004
19
0
0
Blacksburg, VA
Oct 13, 2005
#6
  • Oct 13, 2005
  • #6
I have already bought the part from way back for some reason but never put it on. does the distributor just pull right out, after i make a mark of where it was? all it is, is a shaft with the stuff on top. would there be any other advantage of replacing the whole thing vs me replacing that pip.

plus is it worth the hassle if i'm not sure thats it, or just take it somewhere to be looked at. i'm just sick of spending so much money and time and nothing going anywhere
 
M

mapoff

New Member
Sep 15, 2004
19
0
0
Blacksburg, VA
Oct 15, 2005
#7
  • Oct 15, 2005
  • #7
It was the pip. I just replaced the whole distributor. Was only $60
 
You must log in or register to reply here.

Similar threads

8
Electrical Crank-no start ... no spark ... no injector pulse, was it something I did? (redux)
  • 85gtCOBRA
  • Oct 28, 2025
  • Fox 5.0 Mustang Tech
Replies
2
Views
681
Fox 5.0 Mustang Tech Oct 29, 2025
85gtCOBRA
8
B
Electrical Why does my fox body keep frying eecs
  • brandyn200
  • Jun 20, 2026
  • Fox 5.0 Mustang Tech
Replies
8
Views
517
Fox 5.0 Mustang Tech Jun 25, 2026
AeroCoupe
Resolved 93 Mustang 5.0 - Cranks but does not start
  • dan50
  • Jul 18, 2026
  • Fox 5.0 Mustang Tech
Replies
6
Views
480
Fox 5.0 Mustang Tech Jul 18, 2026
dan50
F
Fox 1990 Mustang GT 5.0 A9L – Engine suddenly shuts off but immediately restarts when key turned
  • FishermansFriend
  • Aug 9, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
16
Views
683
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Aug 30, 2026
General karthief
L
Help with 1986 GT 5 Speed Please
  • Lcasada1999
  • Mar 20, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
7
Views
391
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jun 21, 2026
CAMTWO1070
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?