K-Member Help

[jeffbigwood27]

I just bought a k-member front coil over and all that good stuff. I am just needing to know the torque specs for the bolts the go from the k-member into the frame. Thanks for the help. And it was the UPR k-member and i give it a thumbs up for fitment. Looks good also.

 

[ImportEater98]

i just put mine in last week. I figure its going to hold about 800lbs.....so i torqued it till i couldn't anymore. I think its more important what order you torque the bolts in, than the actual torque applied to them. Obviosly you want to torque them evenly, so start left to right in a criss-cross pattern (like you would lugs on a tire) and you should be fine.

 

[jeffbigwood27]

I see the criss cross pattern but by me torqueing them till i cant anymore i will probably break the bolt. I am not saying i am so strong but with a 1/2 inch drive you can break bolts easily.