Keeping the centercap in???

[gcomfx.com]

Okay guys... looking for recommendations. When I bought my Bullitts from AFSwheels I had one with that didn't want to keep the center caps in. After they nicely sent me 3... they finally decided I should send the wheel back in as it sounded like they CNCed the center a tad too big. I couldn't exactly go without a wheel that easily... so I talked them into selling me two more wheels for cost. I told them I could use the one with the messed up center cap for my drags.

That was like a year ago, and the center cap has been fine since that time. Very strange. Until last week. I caught the little fuaker halfway out. (better than losing it like the last 3) - so here's my question.

What should I do to keep this damn thing in the wheel? The tire shop has to be able to remove them for mounting and balancing right???? Or can I glue the thing in and not worry about it?

Bring on the suggestions.

 

[95tealGT]

I've had the same problem with my AFS Cobra R's. One day after getting home from work, I close my door and I here this "plop". I look over and my centercap is sitting on the street. When I try to fit it back, its like it wasnt even from the same wheels there's so much play in the center.

 

[gcomfx.com]

And.... what did you do?

 

[mystang94gt]

Maybe try sylicon instead of glue. Less messy to cut out when you need to remove it. PLus you can use some clear sylicon so its not visable. Just a thought.

 

[95tealGT]

And.... what did you do?

Nothing. The center cap is still sitting on my kitchen table. I dont think I'll be able to get it to fit back in with any kid of adhesive.