Thanks, yes, Its a car without any rust, and Its nearly stock looking. Like the feeling of having a kind of sleeperSweeeeeet lookin' 4 eye!!! Looks like it's been well taken care of.
Foxfan88, Thanks. Well, Its STEEDA lower alu weightjackers, and STEEDA alu tubular upper Control arms. I use airbags inside my rear springs, and this combo works fine.
I just lift the car 1.5",using the jacker adj. for running my 28inch Racemaster DOT musclecar tires (275/60-15).,I use approx 13psi left side, and 23 psi right side in my springairbags. Strange 10way adj struts and shocks. I rolled my fenders a little, and just some small hammering at the inside chassi.
I have 245/50-16 as street tires, and just lowered the car again for normal street driving. Also have a set of 275/50-15 Racemasters for street and strip.
Good luck, hope you find the right combo for your setup
ps, whats your eight mile numbers ?
Yes, Its the same dimensions as stock, same length, upper and lower. I have checkd my chassi if there is any marks from the tires, but no marks so far.so i am assuming your suspension keeps the samer dimensions as stock? my wheels i drag with has less BS so i am clear width wise, i am clear height wise, i am just worried about the front to back clearence.
i also have aftermarket upper and lower arms, drag springs and shocks and i run flipped quads
my 1/8 mile times are
1.64 60'
7.7@ 87 mph
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?