Leaky Breather

DKeen

New Member
Dec 6, 2004
43
0
0
I have a carb'd 351w in my fox, it came with it hen I purchased the car. I've noticed that the breather spits a decent amount of oil while I drive the car, enough that it gets on things and burns off, and just makes a mess in general.

The car seems to have a pvc system, so could I use a closed crankcase cap? or does my car need a breather?

Thanks, Dan
 
If you choose to keep the breather, you can switch to a closed version, which has a discharge tube. You can route it conveniently to someplace where it can dump (into a can, etc).

Good luck.
 
ahh, thats a good idea. thanks

with a closed breather into a can, will it still be a breathable crankcase though? or will the whole can thing pressurize it?
 
Oh no man, it's not a pressurized (sealed) system. The can is open to atmosphere - it just catches oil out of the discharge tube (You could vent it to the ground, so long as it is done in a way so as to not create a safety/traction issue).

Ford sells a nice lookin breather (Tim - 18Mustangs, has posted a link to it before. I never used that particular model and cant find his link).

Good luck.
 
I see, I'll have to try one of these ideas, it's just starting to get annoying always having oil burning off of my headers, etc.

Oh yeah, is this a really bad sign that I'm getting so much oil out of my breather?
 
Dan, if you dont have baffles (like BO suggested), that can misrepresent how much blowby there is.

In my experience having breathers make a mess is not unusual with low tension rings. It's one reason the show cars guys generally do something else (run a PCV, run closed breathers, a catchcan, etc etc).

Good luck.
 
I have a feeling my rings are probably getting pretty tired. I bought the car with this engine in it, so I don't know everything in/about it. It makes diagnosing things tough. Thanks for the info again.
 
A dry vs wet compression (or leakdown) test can tell ya how the ring seal might be doing.

Good luck Dan.
 
Dan - As rings tire and blow-by increases, more oil will show up through the crankcase ventilation 'system' -- whether it's a close pcv system or an open breather as you have.

How does the current pcv set up work? Is it connected to manifold vacuum, or into the air cleaner? Carb or efi? Does the pcv valve pull from the valve cover or rear of the intake?

If vacuum is pulling on the pcv valve to ventilate the crankcase, then you need a means of make up air for the crankcase so that you won't pull a vacuum on the crankcase. That's the role your breather is performing now. But if you're actually losing a good amount of oil out the breather -- then it sounds like there is more blow by than the pcv valve can handle. And that points to either a clogged pcv system, or a tired engine. If it's a tired engine --- of course the catch can approach is just treating the symtom, not the illness.
 
I'm a little more noobish than I wish I was, but I believe that the current pcv setup pulls from the valve cover to the manifold. Its a carb'd car. I have a feeling the engine is a bit tired, although it pulls like a bat out of hell.

I plan to buy a 408 shortblock sometime in the next few years, and I only drive the car in the summer months, so I guess I'm just trying to deal with it temporarily.