Mach/Bullitt pedal install

[CPB00GT]

I went to the FFW in Gainesville today and had a really good time. I bought some new Ford mach/bullitt pedal covers there. I spent only 5 minutes trying to put the clutch one on, after removing the factory rubber one. It did not work out very well. Is there a trick for a smooth installation of these?

 

[White Stang]

Put them in hot water or leave them in the sun. Then just force them over the pedal with brute force. One of my hardest mods

 

[03redfiregt]

Probably the hardest mod i did! but they look great. I had to heat mine up with a hair dryer to get them soft enough to get over the pedals. Worked great but watch out it will burn your hands.!

 

[StevenGT-02]

i heated mine up with a hair dryer and used a lil soap...once i got some of the pedel on i used a flat head screw druver under the lip to get the rest of it on...Good luck

 

[Jason94gt]

get one lip of the pedal on them take your foot and mash it down clockwise a few times. Easiest way to put the clutch and brake pedal's on