i have an 86 mustang that i have converted over to mass air...i was able to remove the stock harness and replaced it with one from a 91 mustang...the problem is that some of the clips/plugins don't match.
there are a couple up by the mass air sensor...two clips for the thermactor diverter don't match as well as two clips over by the windshield wiper module don't match up either.
however...the biggest problem is down by the EEC. there are two female clips that don't pair up to anything...one is a rectangular 8 pin green connector (it only has 5 or 6 wires to it) and the other is a round grey connector...does anyone know what these are for?
the fuel pump did not prime so i was not able to get the car going.
any suggestions would be appreciated
there are a couple up by the mass air sensor...two clips for the thermactor diverter don't match as well as two clips over by the windshield wiper module don't match up either.
however...the biggest problem is down by the EEC. there are two female clips that don't pair up to anything...one is a rectangular 8 pin green connector (it only has 5 or 6 wires to it) and the other is a round grey connector...does anyone know what these are for?
the fuel pump did not prime so i was not able to get the car going.
any suggestions would be appreciated
