MSD 6A going bad or NOT

[Slow5.0]

A few months ago I got MSD 6A ignition and Blaster High Vibration Coil PN 8222 , I bought udes BUT in good condition , now i'm not sure that stuff workin or not , A few months ago I installed ported (gasket matched) U/L 95 Cobra intake and first night when I tested a car I fell that I lose low end torque realy bad , like when I driving in 2nd around 2K and panched ,car going slow ,but before I installed Cobra intake I have a lot more low end torque and car moving faster (like in 2nd on 2K)
Meybe MSD box goes bad or meybe this is something else, so what you think guys

 

[urban96]

i think that if your MSD box went bad the car would not run at all. you can try bypassing the MSD box and see if that makes any difference

 

[tiny4lx]

Im with urban96 if the msd is bad the car wont start. You said that you upt a U/L ported intake well that could be why the low end tq is missing. Unhook the msd and try.

 

[Slow5.0]

Yesterday I tryed pass MSD box and idle is rough , so I plug MSD box again , MSD box still workin in my car , buy problem is in ported Cobra intake , everybody said I have to lose little bit low end torque

 

[urban96]

timing set correctly?

 

[Slow5.0]

Yes 14* I think , I had little problems with timing when I change intake because I didn't mark gear in distributor , but it's fixed now

 

[94GTStang]

When my MSD 6AL box overheated, it turned my whole car off. Always did it at the worst times too. It's not like I mounted it ontop of the header or anything! Just unplug it and you'll be good to go.

 

[go-stang5.0]

You say rough idle....Did you check for vaccum leaks. THat may be your problem if the intake didnt seal correctly or you forgot to plug a hole in it or something.