Need a Dimension

[NY-67stang]

Anyone have a dimension for the floor crossbrace?
Mine was crooked when I took it off and I want this one straight

A dimension from the rear of the frame rail would be good.
I clamped it and measured about 5 1/4 inches but I'd like some verification

1967 coupe

 

[NasaGT]

I've got a 69, which should be the same I think. I can check it tonight. Just to be clear , are you looking for the measurement from the rear of the floor support to the back of the transmission crossmember?

 

[NY-67stang]

I've got a 69, which should be the same I think. I can check it tonight. Just to be clear , are you looking for the measurement from the rear of the floor support to the back of the transmission crossmember?

This one:

 

[Fstbk]

Does this help?

 

[NasaGT]

Bah, never made it to the garage last night. But I would have measured the wrong thing anyhow. I'll measure it tonight - sending myself an email right now so I won't forget.

 

[NY-67stang]

Does this help?

No. I have this one and another one. It doesn;t give me a dimension. I think I am close enough but I'd like to get another measurement to be sure

 

[NasaGT]

Mine are 5" even. Both driver and pass side measured the same. Again, my car's a 69, so there could be difference between it and your 67. Could be a manufacturing variation too though

 

[NY-67stang]

Mine are 5" even. Both driver and pass side measured the same. Again, my car's a 69, so there could be difference between it and your 67. Could be a manufacturing variation too though

That is where I figured it would be.

Thanks a million. You have been a great help!

 

[free67conv]

I got 5" on my 67 conv and 31"3/4 from the trans support to just under the lower control arm bolt on the apron.

 

[NY-67stang]

I got 5" on my 67 conv and 31"3/4 from the trans support to just under the lower control arm bolt on the apron.

Thanks!