need a new maf, what one to get?

[DemonGT]

i need a new maf and whas looken at the mafs at wmsracing.com....


they have a new pro m 95mm meter that interests me....

 

[Daggar]

Click on the link in my Sig and see if they have what you're looking for.

 

[DemonGT]

oh yea..and i know about the lightening mafs...nice mafs but im looken for something that just hooks up..dont wanna have to use a tuner ect or have to spend XX amount on a chip

 

[DemonGT]

they dont list a 95mm for the foxes...they have a 92mm though...damn spendy....not really sure what one would work best for my application...

 

[9350coupe]

with out a doubt sct big air

 

[Rick 91GT]

Go 80mm.....it will keep velocity up, and it will feed over 800hp with no issues and bolt right in.

 

[DemonGT]

Rick...dont you think the 80 is to small for my motor? i thought the maf was suppose to be the same or bigger then the TB??

just checked Pro m's site..wouldnt want the shorty or the regualar??

they also list a 80,92mm..dose that mean it comes in both sizes or that it starts as a 80mm and then goes up to a 92mm at the other end of the housing?

 

[Rick 91GT]

I was told by the old Pro-M techs when I was building a EFI drag radial combo to go with the 80mm even with an expected 1200hp...it is a better reading meter.

Shorty style, plastic AFM should have them in stock on the shelf ready to go!

 

[DemonGT]

just check over there site again, thought the shortys were for charged cars?

they said they have a 92mm? wonder if anyone has tryed the 92? i already have the 76mm c&l and dont want to buy meter after meter. just want to make sure i get what is best for my application

 

[willys1]

I use to have a 75mm bullet,alot of idle issues I use an 80mm now,,what a difference

 

[DemonGT]

i was reading the Pro M 80mm flows more air then even the 90mm lightening meter? if thats so then why do people use the LMAF?? and i suppose the 92mm is to new for anyone to have tryed?

will most likely go with the 80mm..mabe try to find one used? and sell my C&L

now i just need my upper intakes throttle body opening ported out to 90mm....dont want to have to have to ship it out but i dont think there is anyone localy where i am...anyone have any suggestions on who? id try it myself but knowing my luck id F it up..haha