Need answer quick

[RsStanG1987]

OK MY friend wrecked his sn95 6 banger 3 weeks ago and we are going to go strip it now and take the following.
Rear axl shafts / brakes.
Front spindles ,calipers and rotors
Brake booster
master cylinder
Altenator and wires going to it
seats
Is there anything else i should be taking? And will all of this work for a 5 lug conversion on a Fox?

 

[jackchan]

not sure, I think it should but keep me posted as I wouldnt mind doing the same to mine someday!
Jack

 

[tunedin302]

You never said the year of your friends car. Either way, the brake and seats will work. If it is from a 96+ car then the front spindles will widen the stock track width 8mm on each side. As for the rear, the sn95 axles are 3/4" longer on each side. The seats will bolt in since the floor pan is the same from 79-04 . Often times, the sn95 seats sit higher than the fox style. According to what I have seen/read, the alternator should work but I can't say I have done it.

 

[RsStanG1987]

I think its a 96. Any ways we were planning on selling it so he can get some cash. If he decides not to sell it we are putting it on my car.

 

[Euphoric306]

IIRC v6's got the 7.5 rear? so im not too sure the axels will work

 

[jrichker]

IIRC v6's got the 7.5 rear? so im not too sure the axels will work

Axles from 7.5 & 8.8 are the same.

 

[Thenemesis]

Axles from 7.5 & 8.8 are the same.

:Word: it will all bolt up.. if its a 96 though its 9mm wider..

 

[Euphoric306]

my bad, didnt realize