Hey all i am in the process of drilling and grinding metal to set my camber right for the TC control arms.
Now my question is!! Do i just want to grind out the grooves where the two studs come up through? Or can i also drill out the stationary stud hole also?
The reason i ask is I am about out of room for removing metal for the two studs but wasn't sure if i drilled out the staionary stud if that would screw me.
I was thinking as long as i kept it perfectly aligned that i might be alright. Correct me if i am wrong.
I know i should get the c/c plates but at this time i don't have any cash due to being out of work.
Thanks!!!!
Now my question is!! Do i just want to grind out the grooves where the two studs come up through? Or can i also drill out the stationary stud hole also?
The reason i ask is I am about out of room for removing metal for the two studs but wasn't sure if i drilled out the staionary stud if that would screw me.
I was thinking as long as i kept it perfectly aligned that i might be alright. Correct me if i am wrong.
I know i should get the c/c plates but at this time i don't have any cash due to being out of work.
Thanks!!!!