Need headers for a 2000 body with 302 in it

[bdog9seclx]

Looking for equal length full tubes not outrageously expensive for my setup any ideas or advice?

 

[revhead347]

Any of the 5.0 headers should work. Either the BBK headers or the Mac headers. What kind of transmission do you have?

Kurt

 

[bdog9seclx]

.

i HAVE A MANUAL IN IT. iT ALSO HAS AN X PIPE. rIGHT NOW i HAVE SHORTIES on it but have a blown boss 347 going in with over 500 rwhp so need some headers that will flow enough... Also, with this specific 302 in a 2000 do i treat it as an sn95 part number?

 

[bdog9seclx]

also, is ceramic coating worth %30 more cost? or is Chrome ok?

 

[Adam95GT]

i HAVE A MANUAL IN IT. iT ALSO HAS AN X PIPE. rIGHT NOW i HAVE SHORTIES on it but have a blown boss 347 going in with over 500 rwhp so need some headers that will flow enough... Also, with this specific 302 in a 2000 do i treat it as an sn95 part number?

No... you treat it by what trans you have on it....

 

[bdog9seclx]

On sunmmit there are a set of Dynatech specifically for AJE kmemeber which i have. I wonder if there are any fitment issues with that...also, what application do I purchase a 87-93 or sn95? like i said its an 87-93 5.0 motor in a 2000 v6 body

 

[turbogt]

On sunmmit there are a set of Dynatech specifically for AJE kmemeber which i have. I wonder if there are any fitment issues with that...also, what application do I purchase a 87-93 or sn95? like i said its an 87-93 5.0 motor in a 2000 v6 body

94-95 headers.. 94-04 shell is basically the same

 

[Adam95GT]

94-95 headers.. 94-04 shell is basically the same

Body doesent matter...



like i said its the trans... If you have a 94-95 trans you need 94-95 headers... if you have a fox trans you need fox headers... Its all about the angle of the clutch fork.

 

[bdog9seclx]

so just to be clear i need the 87-93 headers then? Hopefully the AJE K member is compatible and out of the way. I know summit will take a return no hassle