venrick1991
New Member
- Oct 11, 2015
- 24
- 0
- 1
I don't have o2 sensors either and mines an animal,i just had an issue with the distributor,the previous owner was running a 6al box on it and I still have the stock distributor I went as far as re wiring the stock distributor with a stock coil and eliminating the 6al box and it still had the issue,well I suspected un accounted for air the maf was trying adjust to,like a leaking intake gasket so I took the lower intake off and found the gasket to be leaking,you could visibly tell were it sucked it in,keep in mind the car sat for a few years because it needed a transmission,but anyways I replaced the lower intake gaskets and noticed the the I rings on the injector were dry rotted so I replaced all the injector seals and o rings,once the top end was back in place it was still doing the same thing but I had a code for maf sensor out of range so I replaced it and the issue persisted so then after some choice words I pulled the cap and sprayed the silicone lubricant I was talking about earlier all over the hall affect sensor and inside the cap and it started up and ran fine,it runs really strong now with no misses or stutters I hooked the 6al box back up and it runs even better
Sent from my LGL22C using Tapatalk
Sent from my LGL22C using Tapatalk
ing thing works cause it needs the o2 sensors to work correctly. If you really think it does not need the o2 sensors and FORD just over complicated the ecu for no reason.
