Installing an '85 HO into a '90 RX-7. I don't really know about the engine. I just finished getting it bolted in, now I have to find out what goes where.
Any help is appreciated.
1, oil pressure sender?
2, I was thinking brake booster, but doesn't that come from the carb?
3, for the heater?
4, I was told I could just put a small filter on it, true?
5, no idea, but there was one on the other side as well.
6, no idea, but that oval passage dead-ends about 2" inward.
7, coolant temp sender?
8, the coil, what do the wires go to?
9, I was told this is the starter solenoid, what wires go to it?
10, I was told these are cobra headers. I'm guessing this is the o2 sensor bung, is there a preferable way to cap it off?
11, and lastly, the carb that summitracing said I needed for my application, apparently doesn't fit. It's an Edelbrock, I believe it's 500cfm. It hits the lip of the valve cover on either side. Is there a simple solution?
Any help is appreciated.
1, oil pressure sender?
2, I was thinking brake booster, but doesn't that come from the carb?
3, for the heater?
4, I was told I could just put a small filter on it, true?
5, no idea, but there was one on the other side as well.
6, no idea, but that oval passage dead-ends about 2" inward.
7, coolant temp sender?
8, the coil, what do the wires go to?
9, I was told this is the starter solenoid, what wires go to it?
10, I was told these are cobra headers. I'm guessing this is the o2 sensor bung, is there a preferable way to cap it off?
11, and lastly, the carb that summitracing said I needed for my application, apparently doesn't fit. It's an Edelbrock, I believe it's 500cfm. It hits the lip of the valve cover on either side. Is there a simple solution?