Well for starters, i'm not 100% sure but i think these are open vacuum ports....at any rate i always plugged them:
View attachment 309215
Also about the EGR passage on the top of the intake, i can't really see it so i can't really tell if your spacer is covering it properly or not. All i can say about that is maybe take the carb off and double check just by looking all around the spacer to make sure that hole is covered.
I've also seen the infamous "one tooth off" deal with distributors where you've almost got #1 all the way up but not quite and you drop the distributor down but it's a tooth off either way and that'll really screw your timing up.
It's hard to say without being there....and i'm actually dealing with the same hickups on a buddy's car right now. We're gonna swap in a different distributor and ignition and see if that helps and then swap the carb and see if that changes anything.
View attachment 309215
Also about the EGR passage on the top of the intake, i can't really see it so i can't really tell if your spacer is covering it properly or not. All i can say about that is maybe take the carb off and double check just by looking all around the spacer to make sure that hole is covered.
I've also seen the infamous "one tooth off" deal with distributors where you've almost got #1 all the way up but not quite and you drop the distributor down but it's a tooth off either way and that'll really screw your timing up.
It's hard to say without being there....and i'm actually dealing with the same hickups on a buddy's car right now. We're gonna swap in a different distributor and ignition and see if that helps and then swap the carb and see if that changes anything.