Well for starters, i'm not 100% sure but i think these are open vacuum ports....at any rate i always plugged them:
View attachment 309215
Also about the EGR passage on the top of the intake, i can't really see it so i can't really tell if your spacer is covering it properly or not. All i can say about that is maybe take the carb off and double check just by looking all around the spacer to make sure that hole is covered.
I've also seen the infamous "one tooth off" deal with distributors where you've almost got #1 all the way up but not quite and you drop the distributor down but it's a tooth off either way and that'll really screw your timing up.
It's hard to say without being there....and i'm actually dealing with the same hickups on a buddy's car right now. We're gonna swap in a different distributor and ignition and see if that helps and then swap the carb and see if that changes anything.
View attachment 309215
Also about the EGR passage on the top of the intake, i can't really see it so i can't really tell if your spacer is covering it properly or not. All i can say about that is maybe take the carb off and double check just by looking all around the spacer to make sure that hole is covered.
I've also seen the infamous "one tooth off" deal with distributors where you've almost got #1 all the way up but not quite and you drop the distributor down but it's a tooth off either way and that'll really screw your timing up.
It's hard to say without being there....and i'm actually dealing with the same hickups on a buddy's car right now. We're gonna swap in a different distributor and ignition and see if that helps and then swap the carb and see if that changes anything.
She is up and running....never ran so good....I did the coil and re-located, to the fender...new coil wire...new cap,new rotor, I put the new 600 cfm edelbrock on...WOW this car has some punch now...Im going to fine tune it this weekend to hget the most out of it...The best part of all yesterday i was going to watch my Friend play softball..stopped at a light and a guy and his girlfriend pull up to me in some BMW 3 series coupe,,,he had his air on,hr must have shut it off he rolled the windows down and then Actually started reving the motor at me...LOL...so i reved back ...well i did a nice 3000 rpm Launch spun 1st hard hit second i was gone...He was like 3 - 4 cars back on me even while i was spinninf i was ahead of him....lol...Now i need to find this damm ticking noise i think its dirt in a lifter doesnt do it all of the time...what can i use to help that?
