Ok so I am working on the car (1993 Camry V6) that I have been driving recently while my car has been down. Well it needs the radiator replaced and I started that today...It was going good for the first two hoses that I disconnected and then I came to a bolt. I started to take the bolt off and then the piece snapped. The piece I snapped is the hydraulic fan motor.
Now the problem I am having is that there is a line that runs to the fan carrying the fluid that the bolt holds down to the motor. Now I can't get the bolt off the piece that broke off and I dont want to damage the line.
What way would you go about getting this bolt out? Now if I remove the whole line it is going to create even a bigger pain in the ass because I would have to remove the intake to get to the other end of it.
Now the problem I am having is that there is a line that runs to the fan carrying the fluid that the bolt holds down to the motor. Now I can't get the bolt off the piece that broke off and I dont want to damage the line.
What way would you go about getting this bolt out? Now if I remove the whole line it is going to create even a bigger pain in the ass because I would have to remove the intake to get to the other end of it.
