Need help with a motor pull

bear108

Founding Member
Aug 26, 2002
222
0
16
Pa
I know this is a little off the mustang topic and not really sure the right place to post but, here goes. Trying to do a clutch job for a buddy and it is on a 1990 subaru legacy. Everything is dissconnected but, I can't get the motor to split from the bell housing. There isn't much to pry on to get them apart. A little iffy on heating teh line up pins on either side. I am guess that could be my problem.?? Any help, I would so appreciate it. Thanks
 
if its an automatic you have to take the torque converter bolts out :). If its a manual then its time to get out the bfh... that is the rubber bfh.

Also, DO NOT HEAT UP THE DOWEL PINS. I believe your tranny case is magnesium... u dont want to be anywhere near that thing if it goes up. If you know for a fact it isnt magnesium... still follow the advice above :)