Need help with cam on blown motor

[blown1992gt]

I have a 1992 with 40k on the motor stock about 2k ago i installed a vortech a-trim trick flow trach heat upper and lower intake and track heat heads shorty headers off road H-pipe flowmaster mufflers with dumps a 4.10 gear subframe connectors a world class t-5 all . whats holding me up nows is cam selection there are so many out there. so theres my build up what cam do you guys think will work? by the way this car is not a daily driver so im not worried about that. thanks for you help

 

[ExplodingGopher]

Blower cam selecetion:
Lobe separation: 112 to 116 degrees Split pattern: Exhaust duration and lift approximately 10 degrees and .010, respectively, greater than intake. Install cam straight up. Contact a cam manufacturer for lifts and durations that best suit your application.

 

[304billet]

Comp cam XE274HR w/ a 114LC. Call Comp cams to verify if it will clear w/ stock pistons. .555/.565 lift, 224/232 dur @ .050 over.

why r u running shorties on a strip car?

 

[IntenseBlue]

Go custom.

 

[luckythirteen13]

have a custom cam made for you. youll be happier with it then with an off the shelf cam

 

[blown1992gt]

the headers were on the car when i bought it for what im looking for i dont think long tubes will give me anymore proformance than the shorties

 

[RacEoHolic330]

AFM B-31, i enjoy mine greatly