Need Help with Thrust Washers!!!!!

[stroked4.6]

Hello everyone - first post here . I am building a stroked forged 4.6L motor and cant figure out how to install the thrust washers at the end of the crankshaft. Everything went to the machine shop and was balanced so all I need to do now is assemble measure, and degree everything. I've got all the main bearings on but in the stroker kit I received 3 thrust washers - two are identical and the third is slightly different. Could someone please help me out. I cant figure this part out. I was able to get two of them on but not sure if they are seated correctly. I'll post pictures if needed. Any ideas?????
Thanks,
John

 

[stroked4.6]

ttt .... Anyone....

 

[Kilgore Trout]

May as well go ahead and post the pics...

 

[stroked4.6]

Here are a couple pics:

Do I have it set up correctly in picture #1??

 

[stroked4.6]

Here is a picture of all three washers. Not sure how all three will fit or if all three should fit? Any ideas or help would be great!!

 

[screamin gt]

****