Need my driveshaft shortened - where to go?

[jcode68]

Hey guys,
Been a member of Stangnet for a while, usually post in the Classics section. I am in the process of a major drivetrain upgrade (CHP 347, T5, new gears...) and need to find a shop to have my driveshaft shortened. I live in the North Central part of MA, Fitchburg/Leominster area. Anyone reputable reasonably close by before I just start calling from the Yellow Pages? Click here to check out 68 Fastback project. Thanks in advance.

 

[Matt Rise]

Only place I know of is down here in R.I....... Rhode Island Driveshaft. They have been around for about fifty years.

 

[Hissing Cobra]

Try Capeway bearing in Plymouth, Mass. They're in the Camelot Industrial Park on Long Pond Road (Exit 5 off of Route 3). They can fabricate you an entire driveshaft from your u-joint yokes. Years ago, I had them take a look at my 4x4 Ford Ranger's driveshaft (which was bent.) They cut the tube off, welded on a brand new tube and balanced it for me. That took care of my vibration. I'd give you their phone number if I had it handy, but I don't. Look 'em up and ask if they're still doing that type of work. Good luck!

 

[edzo331]

capeway bearing 1-508-747-2800 , talk to steve he does the shaft work

 

[jcode68]

Thanks for the responses guys. I was hoping to find something a little closer than Plymouth, which is about 1 1/2 hour drive one way, but 2 votes back to back for the same shop, I may have to strongly consider it.