Need suggestions for my engine, just got tore apart

[kris54ut]

I was told that this engine came out of a 1991 Mustang Gt with around 60,000 miles on it. Just got the heads off today and everything looks pretty good, just really needs to be cleaned up.

View attachment 362137
View attachment 362139
View attachment 362141
View attachment 362143
View attachment 362145
View attachment 362147
View attachment 362149


What would be best to do at this point?

 

[5spd GT]

Looks nice, just clean it up as you said

What is your budget? Are you looking to add power?

 

[bloopbloob]

go big!!! i regret (as i'm sure many others do) rebuilding my engine back to stockish about 2 years ago. i didnt do any research or really care back then. for not much more $$$ than what i spent i could have a pretty bad-ass engine right now. if not, i'd at least suggest upgrading anything that could be a real p.i.t.a to swap later if you can. ie bottom end stuff, oil pump, timing chain etc that you'd have to tear things apart for.........

 

[Sirone]

Virgin motor. Mmmmm.

 

[NKau]

Depends what you want to do. One thing I will mention is have the block checked out by a machine shop before ordering parts or anything. I bought a 150K mile longblock out of an '87, and despite having terrible looking bearings, it did not need an overbore. Being able to reuse the factory forged pistons saved me a lot of money.

 

[88mouse]

What are you wanting to do with the motor?

At the very least I would rebuild it, and put a cam and some gt40 heads or something on it.

 

[5spd GT]

With 60k, I would save your money on a rebuild.

If you were to do that, go with a stroker, not a basic rebuild.

That would be like throwing money away in my opinion...