According to diagrams ive seen, pin #10 on the ford 60 pin connector to the factory ecu is for the A/C control. Can I just run a wire from this to a spare input on the microsquirt?
The manual that came with mine says it has a spare analogue input for pin 29 (SPAREADC). Also pin #5 SPAREADC2 (MAF)
Ac idle up on the ms2pnp should come in on tableswitch.
Under idle up the input should be tableswitch <polarity> try low first. If setup correctly the AC input light should come on at the bottom of Tuner Studio.
Under idle up the input should be tableswitch <polarity> try low first. If setup correctly the AC input light should come on at the bottom of Tuner Studio.
OK what pnp ecu do you have? can you link it for me?
I am referencing the documentation for the MS2PNP gen2
http://www.megasquirtpnp.com/docs/mspnp_g2_genInstall.php
I am referencing the documentation for the MS2PNP gen2
http://www.megasquirtpnp.com/docs/mspnp_g2_genInstall.php
yup thats a MicroSquirt not a MSpnp... thats why my advice is off.
you may have to pin the open pin 10 to one of the open input pins on the micro.
you may have to pin the open pin 10 to one of the open input pins on the micro.
if there are no other available options. I would have to do a bit of research before i could confidently say yes. If it were a low input yeah but i think the input comes in as 12v.... thats not good for the ECU. a email to the websource you purchased it from would be my suggestion.
Similar threads
- Replies
- 1
- Views
- 446
- Replies
- 8
- Views
- 3K
- Replies
- 5
- Views
- 3K
- Replies
- 8
- Views
- 4K
X
Privacy & Transparency
We use cookies and similar technologies for the following purposes:
- Personalized ads and content
- Content measurement and audience insights
Do you accept cookies and these technologies?
X
Privacy & Transparency
We use cookies and similar technologies for the following purposes:
- Personalized ads and content
- Content measurement and audience insights
Do you accept cookies and these technologies?