New to Hillsboro/Beaverton need help with parts

BeerElf

Founding Member
Oct 16, 2002
85
0
6
Hillsboro, OR
Hey everyone. I recently moved to Hillsboro and I'm putting in a new trickflow intake, 75mm chrome bullet Pro-M, and 30lb. injectors this weekend and it turns out that since my car is a 88 CA mass air GT I have a rectangular mass air plug on my wiring harness and I need a oval one off an 89-93 car to fot the new sensor.

Does anyone know if an auto recycler or some other place where I may be able to get this part? I may give Hillsboro Auto Wrecking a try on Tuesday, but I would really like to be able to finish this up this weekend so I can drive it!

-Craig
 
Any upull it portland, damascus or tigard you can go into the yards. the rest you have to have them pull the part. or Foster Auto Parts as well. American classics is expensive. but right down the road from my home
 
Thanks for the info guys. I'm going to try a u pull it this afternoon, but from my experiences with the pick n pulls in Sacramento you have to be pretty lucky to find anything good. Most of the cars have already been picked over pretty well.

wicked93 - that would be awesome if you had an extra one. I'm going to try a couple places today and tomorrow but I don't know if I'll have any luck.

-Craig
 
picked one up at the Tigard u pull it today. Only cost me a dollar to get in and about 10-15 minutes to find one. All the mustangs were picked pretty clean but I did find a nice SHO with the connecter I needed and what looked like a complete drivetrain in it.

Now I just have some fine tuning to do and a couple hundred more miles till I can switch the new motor over to synthetic.

-Craig
 
!

You have not lived untill you have gone to u pull it with Paul from Krazy Koncepts! Glass? did that car have good glass? not anymore! Pauls tool box is not just for carring tools. Door dinger, fender scratcher, glass breaker. Good therapy for some people!