• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Wheels-Tires Nitto Nt555 R2

  • Thread starter Thread starter Mindseye007
  • Start date Start date May 7, 2022

Mindseye007

5 Year Member
Oct 21, 2020
561
131
63
ontario
May 7, 2022
#1
  • May 7, 2022
  • #1
Like the title says I bought 2 tires for my 1991 foxbody lx 5.0 picking them up next week and installed too, they are 245 50 16 for my pony rims on the rear I used to run Mickey Thompson 255 50 16 but they wore out quick in the center for some reason. Any one tried these Nitto NT555 R2 tires yet ? And what psi for the highway and city streets do you guys recommend?
 
Last edited: Aug 22, 2022

96pushrod

I think they're a little easier to get off
5 Year Member
May 15, 2018
1,530
871
133
Savannah
May 7, 2022
#2
  • May 7, 2022
  • #2
The mt and nitto will both wear out in the center if you run anywhere close to their recommended pressure. I usually put 20psi into them and they wear much more evenly. Never had an issue running them like that.

I’ve ran both of those tires, and will say without a doubt the mt hooks up so much better. Downside to that is they do wear a good bit quicker than the 555r.
 

General karthief

wonder how much it would cost to ship you a pair
5 Year Member
Aug 25, 2016
27,856
10,533
203
polk county florida
May 7, 2022
#3
  • May 7, 2022
  • #3
Old school trick to tire pressure in wide tires was to look at the black tire patch when you 'light em up' for a few feet, dark in the middle too much pressure, dark on the outside not enough pressure, the problem was by the time you get them 'just right ' they were worn out and you had to start over
 
Reactions: Mindseye007

Mindseye007

5 Year Member
Oct 21, 2020
561
131
63
ontario
May 7, 2022
#4
  • May 7, 2022
  • #4
96pushrod said:
The mt and nitto will both wear out in the center if you run anywhere close to their recommended pressure. I usually put 20psi into them and they wear much more evenly. Never had an issue running them like that.

I’ve ran both of those tires, and will say without a doubt the mt hooks up so much better. Downside to that is they do wear a good bit quicker than the 555r.
Click to expand...
I'm thinking of running my tires at 22psi for cruising the streets.
 

Mindseye007

5 Year Member
Oct 21, 2020
561
131
63
ontario
May 7, 2022
#5
  • May 7, 2022
  • #5
Mindseye007 said:
I'm thinking of running my tires at 22psi for cruising the streets.
Click to expand...
Or maybe I'll try them at 24psi....
 

96pushrod

I think they're a little easier to get off
5 Year Member
May 15, 2018
1,530
871
133
Savannah
May 8, 2022
#6
  • May 8, 2022
  • #6
Mindseye007 said:
I'm thinking of running my tires at 22psi for cruising the streets.
Click to expand...

Mindseye007 said:
Or maybe I'll try them at 24psi....
Click to expand...
You could try. I found they really didn’t like anything north of 20.
 

Mindseye007

5 Year Member
Oct 21, 2020
561
131
63
ontario
May 12, 2022
#7
  • May 12, 2022
  • #7
96pushrod said:
You could try. I found they really didn’t like anything north of 20.
Click to expand...
ok going to set them for 20Psi ...what is a good tire gauge to get? I have an electric pump that runs off 12 volts or 120 volts from CanadianTire with a digital readout not sure how accurate it is...
 

96pushrod

I think they're a little easier to get off
5 Year Member
May 15, 2018
1,530
871
133
Savannah
May 13, 2022
#8
  • May 13, 2022
  • #8
Mindseye007 said:
ok going to set them for 20Psi ...what is a good tire gauge to get? I have an electric pump that runs off 12 volts or 120 volts from CanadianTire with a digital readout not sure how accurate it is...
Click to expand...
The digital readouts on the inflators can be suspect, but some do work just fine.

https://www.lowes.com/pd/Kobalt-Inflator-Gun/50126453?cm_mmc=shp-_-c-_-prd-_-tol-_-ggl-_-LIA_TOL_153_Pneumatics-And-Compressors-_-50126453-_-local-_-0-_-0&ds_rl=1286981&gbraid=0AAAAAD2B2W9CAt6RV23tm_noVRD7BzrwN&gclid=Cj0KCQjwg_iTBhDrARIsAD3Ib5hsybgc87hfQL9Iub0GUPIVyVFFMlm4S9Xuv0I0SNtYBZR3nli3y7kaAuEkEALw_wcB&gclsrc=aw.ds

I use one of those. I like to carry it around in the car to check tire pressure, and it has a valve to bleed off pressure if it’s too high. I’ve confirmed it’s accurate with the gauge on our tire changer.

They make other ones in other brands just like it. That style is the one I like.
 

Mindseye007

5 Year Member
Oct 21, 2020
561
131
63
ontario
May 13, 2022
#9
  • May 13, 2022
  • #9
96pushrod said:
The digital readouts on the inflators can be suspect, but some do work just fine.

https://www.lowes.com/pd/Kobalt-Inf...v0I0SNtYBZR3nli3y7kaAuEkEALw_wcB&gclsrc=aw.ds

I use one of those. I like to carry it around in the car to check tire pressure, and it has a valve to bleed off pressure if it’s too high. I’ve confirmed it’s accurate with the gauge on our tire changer.

They make other ones in other brands just like it. That style is the one I like.
Click to expand...
Thanks for that info awesome.
 

Mindseye007

5 Year Member
Oct 21, 2020
561
131
63
ontario
Aug 22, 2022
#10
  • Aug 22, 2022
  • #10
96pushrod said:
The mt and nitto will both wear out in the center if you run anywhere close to their recommended pressure. I usually put 20psi into them and they wear much more evenly. Never had an issue running them like that.

I’ve ran both of those tires, and will say without a doubt the mt hooks up so much better. Downside to that is they do wear a good bit quicker than the 555r.
Click to expand...
I agree the Mickey Thompsons hooked up way better. Then the RII nittos with 21psi 1st hooks pretty good and it now it always chirps 2nd gear.
I put my spare tire back in and my battery is in the trunk it too it seems to ride better with my spare tire back in. But with the Mickey Thompsons and no spare tire it hooked like they were on glue, no spinning and never chirped 2nd it just gets up and goes. Think I might try 25psi with the RII nittos on the street hopefully the centers don't go bald like the Mickey Thompsons did.
 
Last edited: Aug 22, 2022

96pushrod

I think they're a little easier to get off
5 Year Member
May 15, 2018
1,530
871
133
Savannah
Aug 22, 2022
#11
  • Aug 22, 2022
  • #11
Mindseye007 said:
I agree the Mickey Thompsons hooked up way better. The RII nittos with 21psi 1st hooks pretty good and it now it always chirps 2nd gear.
I put my spare tire back in and my battery is in the trunk it too it seems to ride better with my spare tire back in. But with the Mickey Thompsons and no spare tire it hooked like they were on glue, no spinning and never chirped 2nd it just gets up and goes. Think I might try 25psi with the RII nittos on the street hopefully the centers don't go bald like the Mickey Thompsons did.
Click to expand...
I ran 20psi and the centers still went bald. I run 18psi cold on my et streets now.
 

Mindseye007

5 Year Member
Oct 21, 2020
561
131
63
ontario
Aug 22, 2022
#12
  • Aug 22, 2022
  • #12
96pushrod said:
I ran 20psi and the centers still went bald. I run 18psi cold on my et streets now.
Click to expand...
Is that 18 psi on the highways OK?
 

96pushrod

I think they're a little easier to get off
5 Year Member
May 15, 2018
1,530
871
133
Savannah
Aug 22, 2022
#13
  • Aug 22, 2022
  • #13
Mindseye007 said:
Is that 18 psi on the highways OK?
Click to expand...
No problem at all
 
You must log in or register to reply here.

Similar threads

SOLD For Sale '92 LX Street/Drag car - WV
  • MikeyMustang
  • Apr 12, 2025
  • Fox Body Mustangs For Sale (1979-93)
Replies
4
Views
2K
Fox Body Mustangs For Sale (1979-93) Dec 31, 2025
MikeyMustang
Progress Thread "Alter Ego" White 1993 LX 5.0 5spd
  • idareu
  • Sep 9, 2024
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2 3
Replies
42
Views
2K
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Feb 19, 2025
idareu
Tire sizes for pony wheels
  • DemonGT
  • May 3, 2022
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
17
Views
9K
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Aug 22, 2022
Mindseye007
F
For Sale parts fox body mustang
  • FREDDY
  • May 14, 2022
  • Interior Exterior Parts
Replies
2
Views
1K
Interior Exterior Parts May 14, 2022
7991LXnSHO
Place to Avoid: Jamison Auto Group in Gulfport, MS
  • D Durden
  • Oct 20, 2025
  • 1965 - 1973 Classic Mustangs -General/Talk-
  • 2 3
Replies
45
Views
2K
1965 - 1973 Classic Mustangs -General/Talk- Feb 4, 2026
nickyb
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?